COAST SPA”RED” PUMP

 

310-1524 COAST SPAS WATERWAY 5 HP MONSTER FLOW RED PUMP WETEND 56 FRAME 2.5″ X 2″

Here is the Monster Flow RED Pump Wet end made by Waterway, specifically for Coast Spas. For their huge 56″ Frame, 5 HP 20 Amp Pump.

• Coast Spas Monster Flow RED Pump Wetend ( Made by Waterway For Coast Spas)
• 56″ Frame
• 5 Horse Power ( For 20 Amp Motors)
• 5″ Suction x 2″ Discharge ( Note: 2.5″ measures 3 5/8″ OD & 2″  Measures 3 1/16″ OD )

Waterwayparts.com stocks this pump. We also carry the orings, seals, impeller, volute, and face plate.  The entire wet end part number is 310-1524. There is a part number stamped on the back of the wet end CC 3151234

Spa pump cord

Your spa control power cord is dedicated to your model of control and must be re-used on your new pump. New pumps most often ship without a power cord

Remove the cord from your old pump, and note, (take a pic with your phone) the wire color going to high speed or low speed terminals on any motor, the color is set or determined by the maker of the spa control, not by the pump or motor manufacturer. Before you remove the power cord from your old pump, look at the old motor wiring label and make a note of what color goes to high, and to low. Then, put the cord on your new motor/pump, using the same color for high as on the old motor and also for low speed wiring.

THIS IS ONLY AN EXAMPLE!!!!!!

 

MEGA TELEWEIR SKIM FILTER

This slideshow requires JavaScript.

“MEGA” Teleweir is a extra large housing designed for swim spas. The cage style tower eliminates “vortexing” created by the larger swim spa pumps. High capacity 2.5″ socket in/out plumbing and a built in check valve. The hole size needed is 8.5″ diameter and the overall height is 27.5″ to top of weir cap.  This is a 75 square foot cartridge (7″ diameter, 16.25″ tall with closed top) Available at http://www.waterwayparts.com

Part number 519-8350 is molded into the cap.(this is not the part number for the entire unit.  The entire filter in “black” with no logo is 510-4570

Replacement cartridge is available 817-4175 (must be OEM)

 

 

Coast Spa Yellow Pump

Coast Spas 4.5 HP Yellow “wet end”. The pump’s internal parts as well as the housing and motor can go bad and require replacement. When determining the magic number of replacement parts cost versus cost of whole pump, we generally suggest 60-75% as the standard. If the cost to repair is within or over this range, it is smarter to replace the pump. As example, if the cost of the impeller, ceramic seal, faceplate oring, and wear ring exceed 60% of the cost of the entire “wet end”, it is advised to purchase the entire wet end.